Keyless Access System Symptom Troubleshooting Keyless access indicator does not go off or does not come on (2014 - 2015)
- Keyless access system check 1:
- 1. Press the engine start/stop button to select the OFF mode.
- 2. Press the engine start/stop button to select the ON mode.
- 3. Check the keyless access indicator.
Does the keyless access indicator come on for 2 seconds?
YES
Go to step2.
NO
Do the gauge control module self-diagnostic function test - Refer to: Rewriting the ODO Data and Transferring the Maintenance Minder™ Data to a New Gauge Control Module (2014 - 2015), or Gauge Control Module (Tach) Removal and Installation (2014 - 2015), or Gauge Control Module (Speedo) Removal and Installation (2014 - 2015) .
- Keyless access system check 2:
- 1. Check the keyless access indicator.
Does the indicator blink once, then stay off?
YES
Intermittent failure, the system is OK at this time. Check for loose or poor connections.
NO
Go to step3.
- PCU, backup, and keyless access DTC check:
- 1. Check for DTCs in the PCU, backup control unit, and keyless access control unit with the HDS.
Are there any DTCs?
YES
Go to the indicated DTC troubleshooting.
NO
Replace the gauge control module (tach) - Refer to: Rewriting the ODO Data and Transferring the Maintenance Minder™ Data to a New Gauge Control Module (2014 - 2015), or Gauge Control Module (Tach) Removal and Installation (2014 - 2015), or Gauge Control Module (Speedo) Removal and Installation (2014 - 2015) .