Back-Up Light Switch Test

WARNING: This page is about a different variant/trim than selected.

Disconnect the back-up light switch 2P connector (A).

Fig 1: Identifying Back-Up Light Switch 2P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between back-up light switch 2P connector terminals No. 1 and No. 2. There should be continuity when the shift lever is in reverse.
- If the test result is OK, go to step 5.
- If the test result is faulty, go to step 3.
Fig 2: Checking Continuity Between Back-Up Light Switch 2P Connector Terminals No. 1 & No. 2
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the back-up light switch (A). Check for continuity between back-up light switch 2P connector terminals No. 1 and No. 2. There should be continuity when the actuator (B) is pressed, and no continuity when the actuator is released. If the result is faulty, replace the back-up light switch. If the switch is OK, check the reverse shift piece in the transmission.
- If there is continuity, check the reverse shift mechanism in the transmission.
- If there is no continuity, replace the back-up light switch.
Fig 3: Back-Up Light Switch & Washer With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.

BACK-UP LIGHT SWITCH 2P CONNECTOR

Fig 4: Identifying Continuity Between Back-Up Light Switch 2P Connector Terminals No. 1 & No. 2
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the removed or the new back-up light switch with a new washer (C).
Connect the back-up light switch 2P connector.