Immobilizer-keyless Control Unit Replacement
NOTE:
SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX
), and precautions and procedures before doing repairs or servicing (see PRECAUTIONS AND PROCEDURES
).
- Remove the steering column covers (see SIDE DEFOGGER VENT TRIM REMOVAL/INSTALLATION ).
- Disconnect the 7P connector (A) from the immobilizer-keyless control unit (B).
- Remove the two screws and the immobilizer-keyless control unit.
- Install the immobilizer-keyless control unit in the reverse order of removal.
- After replacement, register the immobilizer-keyless control unit (all of the customer's keys are required) (see IMMOBILIZER KEY REGISTRATION ), and make sure the immobilizer system works properly.