DTC 1306: Vehicle Speed Pulse
WARNING: This page is about a different car, the 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Check the vehicle battery condition first.
- Before you troubleshoot, make sure to follow GENERAL TROUBLESHOOTING INFORMATION .
- Clear the hard error code (see HOW TO CLEAR ERROR HISTORY ).
- Turn the ignition switch to LOCK (0), and then start the engine.
- Check for the hard error code (see How to Check Error History
).
Is DTC 1306 indicated?
YES - Go to step 4.
NO - Intermittent failure, the system is OK at this time.
- Go into the Self-Diagnosis mode, and use the Car Status test (see YAW RATE TUNING ) to check the vehicle speed pulse.
- Drive the vehicle, and watch the VSP signal.
Does the VSP signal change from [0] to [7] as you drive?
YES - Replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ).
NO - Do the symptom troubleshooting for vehicle position icon constantly leaves road, moves erratically, or is displayed very far from actual vehicle position (see VEHICLE POSITION ICON CONSTANTLY LEAVES ROAD, MOVES ERRATICALLY, OR IS DISPLAYED VERY FAR FROM ACTUAL VEHICLE POSITION ).