Common Specs & Procedures
FIT COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | AIR CONDITIONING | ||
| Torque | See applicable component in HEATING/AIR CONDITIONING article. | ||
| Axle Nut/Hub Nut | |||
| Front | 181 N.m (134 ft. lbs.) | ||
| Rear | 181 N.m (134 ft. lbs.) | ||
| Battery | BATTERY | ||
| Brakes | |||
| Bleeding Sequence | BRAKE SYSTEM BLEEDING | ||
| Disc Brakes | BRAKES | ||
| Torque | See applicable component in CONVENTIONAL BRAKE COMPONENTS article. | ||
| Charging | |||
| Generator | ENGINE ELECTRICAL | ||
| Torque | See applicable component in ALTERNATOR REMOVAL AND INSTALLATION article. | ||
| Drive Belts | |||
| Adjustment | DRIVE BELT AUTO-TENSIONER INSPECTION | ||
| Belt Routing | DRIVE BELT REMOVAL/INSTALLATION | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM | ||
| Radiator Cap Pressure | 93-123 kPa (0.95-1.25 kgf/cm2 , 14-18 psi) | ||
| Thermostat R & I | THERMOSTAT REPLACEMENT | ||
| Water Pump R & I | WATER PUMP REPLACEMENT | ||
| Engine Mechanical | |||
| Compression | ENGINE ASSEMBLY | ||
| Oil Pressure (176°F (80°C) | 70 kPa (.7 kgf/cm2 , 10 psi) @ idle; 340 kPa (3.5 kgf/cm2 , 50 psi) @ 3000 RPM | ||
| Overhaul | See specifications tables for applicable components in ENGINE SERVICE SPECIFICATIONS - FIT article. | ||
| Torque | See applicable component in one of the following articles: CYLINDER HEAD ENGINE BLOCK ENGINE LUBRICATION INTAKE MANIFOLD AND EXHAUST SYSTEM |
||
| Flywheel/Flex Plate Torque | |||
| A/T | 74 N.m (54 ft. lbs.) | ||
| M/T | 118 N.m (87 ft. lbs.) | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. | ||
| Fuel System | |||
| Pressure Specification | 320-370 kPa (3.3-3.8 kgf/cm2 , 47-54 psi) | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE TEST | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | IGNITION SYSTEM | ||
| Spark Plug (NGK: IZFR6K-13; DENSO: SKJ20DR-M13) | |||
| Gap | 1.2-1.3 mm (.042-.051 in.) | ||
| Torque | 18 N.m (13 ft. lbs.) | ||
| Starting | |||
| Starter | STARTER PERFORMANCE TEST | ||
| Torque | STARTER REMOVAL AND INSTALLATION | ||
| Wheel Alignment | |||
| Adjustment Specifications | SUSPENSION | ||
| Torque | |||
| Front | See applicable component in FRONT SUSPENSION article. | ||
| Rear | See applicable component in REAR SUSPENSION article. | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 108 N.m (80 ft. lbs.) | ||