Grab Handle Removal/Installation

Special Tools Required 

KTC Trim Tool Set SOJATP2014*

*Available through the Honda Tool and Equipment Program, 888-424-6857

1. Lower the grab handle (A), then insert a small flat-tip screwdriver into the notch.
   Fig 1: Inserting Small Flat-Tip Screwdriver Into Notch

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Pull on the small flat-tip screwdriver with the appropriate trim tool (A), and remove the cap (B).
   Fig 2: Pulling On Small Flat-Tip Screwdriver With Appropriate Trim Tool

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Pinch the clips (A) to release the hooks (B), then remove the grab handle (C).
   Fig 3: Identifying Clips, Hooks And Grab Handle

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Pinch the hooks on the clips (A) with a pair of pliers, and pull out the clips of the bracket.
   Fig 4: Pulling Out Clips Of Bracket

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. If the side curtain airbag has deployed, replace the grab handle, along with the other parts listed for side curtain airbag deployment (see COMPONENT REPLACEMENT/INSPECTION AFTER DEPLOYMENT ).
6. If the side curtain airbag has not deployed, inspect the grab handle for damage. A damaged grab handle may cause the side curtain airbags to deploy improperly, possibly causing injury. Replace the grab handle if it has any of the following damage:
   • Any cracks or damages in the grab handle (A).
   • Any cracks or stress-whitening in the caps (B).
     Fig 5: Identifying Grab Handle And Caps

     Courtesy of AMERICAN HONDA MOTOR CO., INC.
7. Install the clips (A) on the grab handle (B), then install the caps (C) fully into the clips.
   Fig 6: Identifying Clips, Grab Handle And Caps

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
8. Position the grab handle (A) on the mounting bracket (B), and push on the grab handle until the clips (C) snap into place securely.
   Fig 7: Identifying Grab Handle, Mounting Bracket And Clips

   Courtesy of AMERICAN HONDA MOTOR CO., INC.