Cruise Control Combination Switch Test/Replacement

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ), before doing repairs or servicing.

1. Remove the driver's airbag (see DRIVER'S AIRBAG REPLACEMENT ).
2. Remove the steering wheel (see STEERING WHEEL REMOVAL ).
Fig 1: Identifying Steering Wheel Trim And Screws
Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Disconnect the 12P connector (A), then remove the cruise control combination switch (B).
   Fig 2: Identifying Cruise Control Combination Switch And 12P Connector

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Check for continuity between the terminals in each switch position according to the table:
   • If there is continuity, and it matches the table, but switch failure occurred on the cruise control input test, check and repair the wire harness on the switch circuit.
   • If there is no continuity in one or more positions, replace the switch.
   Fig 3: Cruise Control Combination Switch Continuity Chart

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
   Fig 4: Identifying Cruise Control Combination Switch Connector Terminal

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Check for continuity between the terminals in according to the table:
   • If there is continuity, and it matches the table, check and repair the wire harness on the switch circuit.
   • If there is no continuity in one or more positions, replace the cruise control combination switch.
   Fig 5: Cruise Control Combination Switch Connection Chart

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
6. Install the cruise control combination switch assembly in the reverse order of removal.