With navigation

The audio-navigation unit has a coded theft protection circuit. Make sure you have the anti-theft security code before:

• Disconnecting the 12 volt battery.
• Disconnecting the audio-navigation unit connector A (24P) and C (8P).
• Removing the No. B1 (15 A) fuse from the under-dash fuse/relay box.

When the audio-navigation unit is reconnected to the power and the ignition switch is turned to ON (II), CODE appears on the display. Enter the 4-digit anti-theft security code.

If the code cannot be found, use the interactive Network (iN) to look it up. You can view the serial number in the ECU Info diagnostic screen (see GPS ). Alternatively, you can find the serial number on the underside label which is located on the audio-navigation unit in the dash.

When replacing the audio-navigation unit, be sure to give the customer the new anti-theft security code.

If you cannot find the code, refer to the Anti-Theft Feature in the navigation section (see GENERAL TROUBLESHOOTING INFORMATION ) on how to retrieve the code using the iN.