Immobilizer-Keyless Control Unit Registration: Procedure

WARNING: This page is about a different variant/trim than selected.

1. HDS DLC - Connection

Courtesy of HONDA, U.S.A., INC.

1. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard

2. Turn the ignition switch to ON (II)

3. Make sure the HDS communicates with vehicle. If it does not communicate, go to the DLC circuit troubleshooting.

2. Immobilizer Keyless Control Unit Registration

1. Have all registered keys and the ECM/PCM code

2. Select IMMOBI from the SYSTEM SELECTION MENU, then select IMMOBILIZER SETUP

3. Select REPLACE IMMOBILIZER RECEIVER/KEYLESS CONTROL UNIT

4. Do the registration according to the instructions on the HDS screen

5. Check if the engine can be started with the newly registered keys

6. When prompted by the HDS, do the keyless transmitter programming

7. Make sure the keyless transmitter's operation works properly.