Cruise Control Input Test

Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2 on GENERAL TROUBLESHOOTING INFORMATION ).
Turn the ignition switch to ON (II).
Make sure the HDS communicates with the vehicle and the engine control module (ECM)/powertrain control module (PCM). If it doesn't communicate, troubleshoot the DLC circuit (see DLC CIRCUIT TROUBLESHOOTING ).
Go to PGM-FI, and check for DTCs (see GENERAL TROUBLESHOOTING INFORMATION ).

Do the following tests while monitoring parameters in the PGM-FI DATA LIST with the HDS.

NOTE: Intermittent failures are often caused by loose circuit connections. While monitoring cruise control inputs, flex their circuit wires, and note if any of the test results change.

TEST CONDITION TABLE

Signal to be tested	Test condition	Parameter: Desired result	Possible cause if result is not obtained
Brake pedal position switch signal	Brake pedal pressed, then released.	CRUISE BRAKE SW should indicate OFF when the brake pedal is pressed and ON when the brake pedal is released.	Faulty brake pedal position switch Blown No. 24 (10 A) fuse in the under-dash fuse/relay box An open in the wire between the ECM/PCM and the brake pedal position switch A wire shorted to ground between the ECM/PCM and the brake pedal position switch
Clutch pedal position switch signal (M/T model)	Clutch pedal pressed, then released	SHIFT/CLUTCH SW should indicate OFF when the clutch pedal is pressed and ON when the clutch pedal is released.	Faulty clutch pedal position switch An open in the wire between the ECM and the clutch pedal position switch A wire shorted to ground between the ECM and the clutch pedal position switch Poor ground G401
Set switch signal	Set/decel button pressed and released	CRUISE SET SW should indicate ON when the set/decel button is pressed and OFF when the set/decel button is released.	Faulty cruise control combination switch An open in the wire between the gauge control module and the cruise control combination switch A wire shorted to ground between the gauge control module and the cruise control combination switch
Resume switch signal	Resume/accel button pressed and released	CRUISE RESUME SW should indicate ON when the resume/accel button is pressed and OFF when the resume/accel button is released.	Faulty cruise control combination switch An open in the wire between the gauge control module and the cruise control combination switch A wire shorted to ground between the gauge control module and the cruise control combination switch
Cancel switch signal	Cancel button pressed and released	CRUISE CANCEL SW should indicate ON when the cancel button is pressed and OFF when the cancel button is released.	Faulty cruise control combination switch An open in the wire between the gauge control module and the cruise control combination switch A wire shorted to ground between the gauge control module and the cruise control combination switch
Cruise control main switch signal	Cruise control main switch ON and OFF	CRUISE MAIN SW should indicate ON when the cruise control main switch is turned ON and OFF when the cruise control main switch is turned OFF.	Faulty cruise control combination switch An open in the wire between the gauge control module and the cruise control combination switch A wire shorted to ground between the gauge control module and the cruise control combination switch An open in the wire between the cruise control combination switch and ground
Cruise control indicator signal	Start the engine, turn the cruise control main switch on, and drive the vehicle above 25 mph (40 km/h). Set and cancel the cruise control.	CRUISE INDICATOR should indicate ON when the cruise control is set and OFF when the cruise control is canceled.	Faulty gauge control module