DTC 27-13: Steering Angle Sensor Output Signal Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).

Turn the ignition switch to ON (II), and set the front wheels to the straight ahead position.
Turn the steering wheel one turn to the left. Check the STEERING ANGLE in the VSA DATA LIST with the HDS.
Is there about -288 degrees to -432 degrees?

YES -Intermittent failure, the system is OK at this time. Refer to INTERMITTENT FAILURES TROUBLESHOOTING

NO -Replace the steering angle sensor (see STEERING ANGLE SENSOR REPLACEMENT ).