Exploded View: Disassembly
- Drain the fluid from the power steering pump (see FLUID CHECK/REPLACEMENT
).
- Remove the power steering pump (see PUMP REPLACEMENT
).
- Hold the power steering pump (A) in a vise with soft jaws (B), then hold the pulley (C) with the pulley holder (D), and remove the pulley nut (E) and pulley. Be careful not to damage the pump housing with the jaws of the vise.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Remove the inlet joint and 14.8 mm O-ring.
- Loosen the flow control valve cap, and remove the cap, 16.7 mm O-ring, flow control valve, and flow control valve spring.
- Remove the pump cover and pump cover seal.
- Remove the cam ring, outer case, rotor, vanes, side plate, and 23.8 mm O-ring.
- Remove the pump housing cap, 12.7 mm O-ring, and the pump preload spring.
- Remove the 40 mm snap ring, then remove the driveshaft by tapping the shaft end with a soft face hammer.
- Remove the pump seal from the pump housing.