DTC P0339: CKP Sensor Circuit Intermittent Interruption

NOTE: 

• Before you troubleshoot, review the general troubleshooting information - Refer to: How to Troubleshoot the Fuel and Emissions SystemsHow to Troubleshoot the CVT System(CVT System) .
• If A/T system DTCs are stored at the same time as DTC P0339, troubleshoot A/T system DTCs first, then recheck for DTC P0339.

DTC (PGM-FI)

• 1. Problem verification (idling):

  - 1. Turn the vehicle to the ON mode.

  - 2. Clear the DTC with the HDS.

  - 3. Start the engine, and let it idle for 10 seconds.

  - 4. Monitor the OBD STATUS for DTC P0339 in the DTCs MENU with the HDS.

  DTC Description	OBD STATUS
  P0339 CKP Sensor Circuit Intermittent Interruption

  Does the HDS indicate FAILED?

  YES 

  The failure is duplicated. Go to step 3.

  NO 

  If the HDS indicates PASSED, go to step 2. If the HDS indicates NOT COMPLETED, keep idling until a result comes on.

• 2. Problem verification (test-drive):

  - 1. Test-drive the vehicle for several minutes in the range of these recorded freeze data parameters:

  • ENGINE SPEED
  • VEHICLE SPEED

  - 2. Monitor the OBD STATUS for DTC P0339 in the DTCs MENU with the HDS.

  DTC Description	OBD STATUS
  P0339 CKP Sensor Circuit Intermittent Interruption

  Does the HDS indicate FAILED?

  YES 

  The failure is duplicated. Go to step 3.

  NO 

  If the HDS indicates PASSED, intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the CKP sensor and the PCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot. If the HDS indicates NOT COMPLETED, retest and check the OBD STATUS again.

• 3. CKP sensor circuit connectors and terminals condition check:

  - 1. Check for poor connections or loose terminals at these locations:

  • CKP sensor
  • PCM
  • Engine ground
  • Body ground

  Are the connections and terminals OK?

  YES 

  Go to step 4.

  NO 

  Repair the connections or terminals.

• 4. CKP pulse plate visual check:

  - 1. Remove the CKP sensor , and check for damage to the CKP pulse plate.

  Is the pulse plate damaged?

  YES 

  Replace the CKP pulse plate .

  NO 

  Replace the CKP sensor .