Voice Control Switch Test

SRS components are located in this area. Review the SRS component location (see COMPONENT LOCATION INDEX ), and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) in the SRS section before doing repairs or service.

1. Remove the HFL-navigation voice control switch (see VOICE CONTROL SWITCH TEST  ).
   Fig 1: Measuring Resistance Between Terminals No. 2 And No. 4

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Measure the resistance between terminals No. 2 and No. 4 in each switch position according to the table.
   TERMINAL RESISTANCE REFERENCE CHART
   
   

   Position	Resistance
   No button pressed	About 10 kΩ
   Navigation TALK button	About 2.2 kΩ
   Navigation BACK button	About 652 Ω

3. If the resistance is not as specified, replace the HFL-navigation voice control switch (see VOICE CONTROL SWITCH TEST  ).