Steering Column/EPS Control Unit Removal and Installation (KA/KC models): Installation

NOTE: 

• SRS components are located in this area. Review the SRS component locations and the SRS precautions and procedures before doing repairs or service.
• Do not release the lock lever until the steering column/EPS control unit is installed. If the lock lever is released before installation, adjust the steering column after installation.

1. Steering Column/EPS Control Unit - Install
   Fig 1: Steering Column And EPS Control Unit Tightening Sequence With Torque Specifications

   Courtesy of HONDA, U.S.A., INC.

   2. Tighten the bolts (B) and the nuts (C) to the specified torque in the numbered sequence shown

   3. Install the clips (D)

   4. Connect the connectors (E).

   Without keyless access system  Courtesy of HONDA, U.S.A., INC.HONDA, U.S.A., INC. With keyless access system  Courtesy of HONDA, U.S.A., INC.HONDA, U.S.A., INC.

   5. Install the clips (A) 6. Connect the connector(s) (B).

2. Brake Pedal Position Switch - Install
3. Brake Pedal Position Switch - Adjust
4. Driver's Dashboard Lower Cover - Install
5. Combination Switch - Install
   Fig 2: Combination Switch Tightening Sequence

   Courtesy of HONDA, U.S.A., INC.HONDA, U.S.A., INC.

   1. Install the combination switch (A) 2. Tighten the screws (B) in the numbered sequence shown.

   Courtesy of HONDA, U.S.A., INC.

   3. Connect the connectors (A).

6. Column Cover - Install 
7. Steering Joint - Connect

   Courtesy of HONDA, U.S.A., INC.

   1. Cut the wire (A) 2. Slip the lower end of the steering joint (B) onto the pinion shaft (C). NOTE:  Pinion shaft with center guide: Install the steering joint by aligning the center guide (D). Pinion shaft without center guide: Position the steering column by aligning the gap (E) within the angle.

   Courtesy of HONDA, U.S.A., INC.

   3. Align the bolt hole (A) on the steering joint with the groove (B) around the pinion shaft 4. Loosely install the new steering joint bolt (C) 5. Be sure that the joint bolt is securely in the groove in the pinion shaft 6. Tighten the steering joint bolt to the specified torque 7. Pull on the steering joint to make sure that the steering joint is fully seated.

8. Steering Joint Cover - Install
   Fig 3: Steering Joint Cover Tightening Sequence

   Courtesy of HONDA, U.S.A., INC.

   1. Install the clip (A) and the push nuts (B) in the numbered sequence shown. NOTE:  Check the steering joint cover for damage and cracks. If the steering joint cover is cracked, replace the steering joint cover.

9. Steering Wheel - Install 
10. 12 Volt Battery Terminal - Connect
11. Steering - Check

    1. After installation, check these items: Start the engine, allow it to idle, and turn the steering wheel from lock to lock several times. Check that the EPS indicator does not come on. Check the steering wheel spoke angle. If steering spoke angles to the right and left are not equal (steering wheel and rack are not centered), correct the engagement of the joint/pinion shaft splines.

12. Wheel Alignment - Check
13. VSA sensor neutral position memorization