October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
VSA Modulator-Control Unit Removal and Installation: Installation
- Install the VSA modulator-control unit (A) onto the bracket (B).
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Install the VSA modulator-control unit (A) with the bracket (B) to the body, then install the VSA modulator-control unit bracket mounting bolts (C).
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Align the connecting surface of the VSA modulator-control unit 36P connector (A) to the VSA modulator-control unit.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Pull up the lever (B) of the VSA modulator-control unit 36P connector, then confirm the connector is fully seated.
- Connect the 10 mm brake lines and the 12 mm brake lines to the VSA modulator-control unit (A).
NOTE:
Brake lines are connected to the master cylinder (B), the right-front (C), the left-rear (D), the right-rear (E), and the left-front (F) brake systems.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Install the air cleaner (see
THROTTLE BODY CLEANING
).
- Bleed the brake system (see
BRAKE SYSTEM BLEEDING
).
- Do the VSA modulator-control unit update (see VSA MODULATOR-CONTROL UNIT UPDATE
).
- Do the VSA sensor neutral position memorization procedure (see VSA SENSOR NEUTRAL POSITION MEMORIZATION
).