Test Procedure
- 1. Rear Door Power window Switch Panel - Remove
- 2. Rear Power Window Switch - Test
Without Door Multiplex Control Unit
1. Check for continuity between the terminals in each switch position according to the table.
2. If the continuity is not specified; replace the rear power window switch (A) - Refer to: Rear Power Window Switch Removal and InstallationFront Passenger's Power Window Switch Removal and Installation .
With Door Multiplex Control Unit 1. Remove the rear power window switch.
2. Swap the rear power window switch with another known-good power window switch and test. If the original power window switch is faulty; replace it - Refer to: Rear Power Window Switch Removal and InstallationFront Passenger's Power Window Switch Removal and Installation .
- 3. All Removed Parts - Install - Install the parts in the reverse order of removal.