DTC U3000-51: Reprograming Error

DTC (Gauge Control Module)

NOTE: 

• Before update the gauge control module, make sure the 12 volt battery in the vehicle is fully charged, and connect a jumper 12 volt battery (not a battery charger) to maintain system voltage.
• Never turn the vehicle to the ACCESSORY mode or OFF (LOCK) mode, during the reprogramming. If there is a problem with the reprogramming, turn the vehicle to the ON mode.

• 1. Problem verification:

  1. Clear the DTCs with the HDS.

  2. Turn the vehicle to the OFF (LOCK) mode and then the ON mode.

  3. Check for DTCs with the HDS.

  DTC Description	DTC
  U3000-51 Reprograming Error

  Is DTC U3000-51 indicated?

  YES 

  Reprograming the gauge control module.

  NO 

  Intermittent failure, the system is OK at this time.