Fuel Line/Quick-Connect Fitting Precautions

When removing or installing the fuel feed hose/line, or when disconnecting or connecting the quick-connect fittings, pay attention to the following:

NOTE:  Replace the fuel feed hose, fuel line, or the quick-connect fitting to new one if it damaged.

• No heat-resistance; Be careful not to damage them during welding or other heat-generating procedures.
• No acid-proof; Do not touch them with a shop towel that was used for wiping 12 volt battery electrolyte or something similar.
• No stress-resistance; Be careful not to bend or twist the fuel feed hose/line excessively.

A disconnected quick-connect fitting can be reconnected, but the retainer on the mating line cannot be reused once it has been removed from the line. Replace the retainer when:

• Replacing the fuel feed line
• Replacing the fuel rail
• Replacing the fuel tank unit
• Replacing the fuel filter
• Replacing the EVAP canister (USA and Canada models)
• Replacing the EVAP purge line (USA and Canada models)
• Replacing the fuel fill pipe (USA and Canada models)
• Replacing the fuel tank
• The retainer has been removed from the pipe
• The retainer is damaged

NOTE:  Use the same manufacturer retainer and the same size retainer when the replacing the retainer.

Courtesy of HONDA, U.S.A., INC.

Courtesy of HONDA, U.S.A., INC.

Courtesy of HONDA, U.S.A., INC.

USA and Canada models 

Courtesy of HONDA, U.S.A., INC.

Mexico models 

Courtesy of HONDA, U.S.A., INC.

USA and Canada models 

Courtesy of HONDA, U.S.A., INC.

USA and Canada models 

Courtesy of HONDA, U.S.A., INC.