VSA Modulator-Control Unit Update: Procedure

NOTE:  High temperature in the engine compartment might cause the VSA modulator-control unit to become too hot to run the update. If the engine has been running before this procedure, open the hood and cool the engine compartment.

1. VSA Modulator-Control Unit - Update

   NOTE:  Check any official service website for more information about updating the MVCI and control units.

2. VSA Sensor Neutral Position - Memorize 
3. Clutch Pedal Stroke Sensor Zero Point - Learn (M/T)

   1. Turn the vehicle to the ON mode without pressing the clutch pedal. 2. Wait for 2 seconds, then make sure that the VSA indicator goes OFF. NOTE: If the VSA indicator goes OFF, the clutch pedal stroke sensor zero point learning is complete. If the VSA indicator blinks, the learning failed. Turn the vehicle to the OFF mode, and try again.

4. TPMS - Calibrate (With TPMS)