Immobilizer System Registration: Procedure

• The HDS is required for registration of the immobilizer keys.
• Programming the immobilizer also programs the keyless transmitter.
• Check for aftermarket electrical equipment that can cause problems with transponder operation.
• The immobilizer-keyless control unit can store up to six immobilizer keys.

1. Have all keys to be registered and the PCM code.

2. Connect the HDS to the data link connector (DLC).

3. Turn the vehicle to the ON mode.

4. Select IMMOBI from the SYSTEM SELECTION MENU, then select IMMOBILIZER SETUP.

5. Select REPLACE IMMOBILIZER RECEIVER/CONTROL UNIT.

6. Do the registration according to the instructions on the HDS screen.

NOTE:  Program all of the customer's keys.

7. Check that the engine can be started with the registered keys.

8. When prompted by the HDS, do the keyless transmitter programming.

9. Make sure the keyless transmitter's operation works properly.