DTC 1702
DTC 1702 : XM Antenna Error
NOTE:
- Check the vehicle 12 volt battery condition first .
- This navigation DTC sets when there is poor connectors or loose terminals at the XM antenna connector or an open in XM antenna lead.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information .
- Check any official Honda service website for more service information about the navigation system.
- Check the connectors for poor connections or loose terminals.
- Problem verification
-1. Clear the hard error codes .
-2. Turn the vehicle to the OFF (LOCK) mode then the ON mode.
-3. Turn on the audio system, and select the XM radio.
-4. Check for hard error codes .
Is DTC 1702 indicated?
YES
The failure is duplicated, go to step 2.
NO
Intermittent failure, the system is OK at this time.
- XM antenna check (substitution)
-1. Clear the hard error codes .
-2. Turn the vehicle to the OFF (LOCK) mode.
-3. Substitute a known-good roof antenna .
-4. Turn the vehicle to the ON mode.
-5. Turn on the audio system, and select the XM radio.
-6. Check for hard error codes .
Is DTC 1702 indicated?
YES
Go to step 3.
NO
Replace the original roof antenna.
- XM receiver check (substitution)
-1. Clear the hard error codes .
-2. Turn the vehicle to the OFF (LOCK) mode.
-3. Substitute a known-good XM receiver .
-4. Turn the vehicle to the ON mode.
-5. Turn on the audio system, and select the XM radio.
-6. Check for hard error codes .
Is DTC 1702 indicated?
YES
Replace the XM antenna lead.
NO
Replace the original XM receiver.