Intake Manifold Removal and Installation: Removal

NOTE:  Refer to the Exploded View if needed during this procedure.

1. Fuel Pressure - Relieve

   NOTE:  After relieving the fuel pressure, do not connect the quick-connect fitting.

2. 12 Volt Battery Terminal - Disconnect
3. Air Cleaner - Remove 
4. Intake Air Duct - Remove 
5. Connector (MAP Sensor) - Disconnect 
6. EVAP Canister Purge Hose, Brake Booster Vacuum Hose, and PCV Hose - Disconnect

   Courtesy of HONDA, U.S.A., INC.

   1. Disconnect the EVAP canister purge hose (A), the brake booster vacuum hose (B), and the PCV hose (C).

7. Throttle Body - Move 

   NOTE:  Do not disconnect the water bypass hoses.

8. Heater Hose Clamp Bracket - Remove

   Courtesy of HONDA, U.S.A., INC.

   1. Remove the heater hose clamp bracket.

9. Engine Undercover - Remove (With Engine Undercover)
10. Intake Manifold Bracket - Remove

    Courtesy of HONDA, U.S.A., INC.

11. Connector (IMT Valve Actuator) - Disconnect

    Courtesy of HONDA, U.S.A., INC.

    1. Disconnect the connector (A). 2. Remove the harness clamps (B).

12. Intake Manifold - Remove
    Fig 1: Intake Manifold Bolts Loosening Sequence

    Courtesy of HONDA, U.S.A., INC.

    Courtesy of HONDA, U.S.A., INC.