Security Indicator Blinks

-1. Select KEYLESS ACCESS CONTROL UNIT from the ONE-PUSH START system select menu with HDS, and enter KEYLESS ACCESS SYSTEM INFORMATION.

- 2. Do the SYSTEM CHECK 1 and 2 with the HDS.

SYSTEM CHECK

Are N-1 OK and N-2 OK indicated?

YES 

Go to step 2.

NO 

Troubleshoot the keyless access system according to the result of the SYSTEM CHECK 1 and 2.

-1. With driver's power window open and all the doors closed, turn the vehicle to the OFF (LOCK) mode.

- 2. Remove all the keyless remotes from inside the vehicle. Hold them outside the open driver's window, at least 20 cm (7.9 in) away from the vehicle.

- 3. Press the engine start/stop switch button. The MID should request the keyless remote to touch the engine start/stop button. The LED on the engine start/stop button will flash for up to 30 seconds.

- 4. Touch the engine start/stop switch with the keyless remote. The buttons on the keyless remote should be facing you. The LED on the engine start/stop button will turn solid when detected.

- 5. Turn the vehicle to the ON mode.

- 6. Select BACKUP CONTROL UNIT from the ONE-PUSH START system select menu with the HDS, and enter SYSTEM INFORMATION.

- 7. Do the SYSTEM CHECK with the HDS.

System Check

Is N-1 OK indicated?

YES 

Go to step 3.

NO 

Troubleshoot the keyless access system according to the result of the SYSTEM CHECK.

-1. Select GAUGES from the BODY ELECTRICAL SYSTEM SELECT menu with the HDS.

- 2. Select FUNCTIONAL TESTS from the TEST MODE menu with the HDS, and enter SELF TEST.

FunctionTest

Does the security indicator blinkΩ

YES 

Go to the PGM-FI system troubleshooting - Go to: How to Troubleshoot the Fuel and Emissions Systems .

NO 

Replace the Gauge Control Module - Removal and Installation .