PCM (6-Speed A/T), ('16-'18 9-Speed A/T): Installation

NOTE: 

• If you are removing the PCM, skip the procedures of using the HDS.
• If you are substituting the PCM, skip the procedures of WRITE DATA (Engine Oil Life and Starter Counter).

1. PCM - Install
   Fig 1: PCM With Torque Specifications

   Courtesy of HONDA, U.S.A., INC.

   1. Install the cover (A) and the bracket (B).

   Fig 2: PCM Cover And Bracket (B) With Torque Specifications

   Courtesy of HONDA, U.S.A., INC.

   2. Install the PCM assembly (D). 3. Connect PCM connectors A, B, and C. NOTE:  PCM connectors A, B, and C have symbols (A=□, B=Δ, C=◦) embossed on them for identification. 4. Install the connector (E), and the harness holder (F).

2. Front Bulkhead Cover - Install
3. SCS - Open

   1. Exit the SCS mode with the HDS.

   Procedure After Replacing PCM 

4. VIN - Input

   1. Turn the vehicle to the ON mode. NOTE:  DTC P0630 VIN Not Programmed or Mismatch may be stored because the VIN has not been programmed into the PCM; ignore it, and continue this procedure. 2. Manually input the VIN to the PCM with the HDS.

5. WRITE DATA (Engine Oil Life and Starter Counter) - Select (USA and Canada Models)

   NOTE:  If the READ DATA (engine oil life and starter counter) failed in "READ DATA (Engine Oil Life and Starter Counter) - Select", skip this procedure. 1. Select the REPLACE PCM MENU, then select WRITE DATA, and follow the screen prompts.

6. Other Procedures for PCM Replacement - Do (USA and Canada Models)

   1. If the READ DATA (engine oil life) failed in "READ DATA (Engine Oil Life and Starter Counter) - Select", replace the engine oil and the engine oil filter .

7. Keyless Access System - Registration
8. DTC - Clear

   1. Clear the Pending or Confirmed DTCs with the HDS.

9. PCM - Update
10. PCM - Idle Learn
11. CKP Pattern - Clear/Learn