Intake Manifold Removal and Installation (2017 2018 2019): Installation
NOTE:
- How to read the torque specifications .
- Refer to the Exploded View if needed during this procedure.
- Intake Manifold Base - Install
1. Install the intake manifold base. Tighten the bolts/nuts in three steps; tighten the bolts/nuts until the bolts/nuts sit on the intake manifold base, tighten the bolts/nuts until the gasket is compressed, tighten the bolts/nuts to specified torque. NOTE: Always use new gaskets. - Intake Manifold - Install
1. Install the intake manifold. Tighten the bolts/nuts in three steps; tighten the bolts/nuts until the bolts/nuts sit on the intake manifold, tighten the bolts/nuts until the gasket is compressed, tighten the bolts/nuts to specified torque. NOTE: Always use new gaskets. - EGR Pipe B - Install
- Brake Booster Vacuum Hose and PCV Hose - Connect
1. Connect the brake booster vacuum hose (A) and the PCV hose (B). 2. Install the hose clamps (C).
- Throttle Body and Intake Air Duct - Install NOTE:
Always use a new throttle body gasket.
- EVAP Canister Purge Hose and Connector (EVAP Canister Purge Valve) - Connect
- Air Cleaner - Install
- Injector Control Module - Install