| Cannot select ON mode with keyless access and with the keyless remote touching the power switch |
Symptom troubleshooting |
- Check the No. B1
, No. B2-3
, No. B3-3
, No. B3-4
, and No. B21
fuses
- Check the No. D3 fuse
- Poor connections at the body control module
- +B P-ACT DRV line open
- GND line open/short or poor ground
- SS1(+) line open/short
- SS2(-)line open/short
- TCU WAKE UP line open/short
- IGNTRX line open/short
- L-line
- Keyless remote
- Body control module
- Harness/connectors
- Power switch
|
| Cannot select ON mode with keyless access, but can select ON mode with the keyless remote touching the power switch |
Symptom troubleshooting |
- Body control module
- LF antenna
- Keyless remote
- RF unit
- Low or weak keyless remote battery
- Harness/connectors
|
| Cannot select ON mode with the keyless remote touching the power switch, but can select ON mode with keyless access |
Check the body control module |
- Body control module is not registered
- Body control module
- Not registered
- IGNTRX line open/short
- Harness/connectors
|
| The mode changes between ACCESSORY and ON, but it does not change to OFF (LOCK) |
- Check the body control module
- Check the SBW shifter control module
|
- Body control module
- ATP-P line open
- SBW shifter control module
|
| The mode changes between ACCESSORY and ON, but it is difficult to change to OFF (LOCK) |
- Check the body control module
- Check the gauge control module
|
- Gauge control module
- Body control module
- PCM
- B-CAN communication line open/short
- F-CAN communication line open/short
- Speed signal line open
|
| Power switch does not work |
Check for DTCs. If any DTC is indicated, go to the DTC troubleshooting |
- ACC relay circuit
- Body control module
- Power switch
- SS1(+) line short
- SS2(-) line short
- Harness
|