DTC P0716: Input / Turbine Speed Sensor "A" Circuit Range / Performance
NOTE:
- Before you troubleshoot, review the General Troubleshooting Information - Refer to: or How to Troubleshoot the CVT System(CVT) .
- This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P0716 Input/Turbine Speed Sensor "A" Circuit Range/Performance |
DTC (CVT)
- Problem verification:
- 1. Turn the vehicle to the ON mode.
- 2. Clear the DTC with the HDS.
- 3. Turn the vehicle to the OFF (LOCK) mode.
- 4. Raise the vehicle on a lift. Make sure it is securely supported, and allow all four wheels to rotate freely.
- 5. Start the engine.
- 6. Disable the VSA by pressing the VSA OFF button (with VSA).
- 7. Test-drive the vehicle at speeds over 19 mph (30 km/h) for at least 30 seconds. Slow down, and stop the wheels.
- 8. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P0716 Input/Turbine Speed Sensor "A" Circuit Range/Performance Is DTC P0716 indicated?
YES
The failure is duplicated. Go to step 2.
NO
Intermittent failure, the system is OK at this time. Check for poor connections and loose terminals between the torque converter turbine speed sensor and the PCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.
- Torque converter turbine speed sensor check:
- 1. Rotate the front wheels with the shift lever in D position/mode, and compare the Torque Converter Turbine Speed and the Input Shaft(Drive Pulley) Speed rpm in the Data List with the HDS.
Signal Current conditions Values Unit Torque Converter Turbine Speed Input Shaft(Drive Pulley) Speed rpm Are the speeds about the same?
YES
The torque converter turbine speed sensor is OK. Update the PCM if it does not have the latest software , or substitute a known-good PCM , then recheck. If DTC P0716 goes away and the PCM was updated, troubleshooting is complete. If DTC P0716 goes away and the PCM was substituted, replace the original PCM .
NO