Unit Check (Quick Check)

These screens allow you to diagnose the audio unit and related units. Some of the tests and screens that are displayed under the Unit Check are same as the checks listed under the Detail Information & Setting.

To start the test, select the item you want to check.

NOTE: These items describe in indication order.

DA Unit
F-CAN
B-CAN
USB
SD
Vehicle Status
HFT/Mic
Hard Key
Error History
Rear Wide Camera
LaneWatch (with LaneWatch)
Radio
Display
A/C
GPS Antenna
MirrorLink
iPhone
Real VNC

Courtesy of HONDA, U.S.A., INC.

DA Unit

This diagnosis looks for problems in the audio unit ECU. When you start this diagnosis, the audio unit may freeze or delay up to a minute while the diagnosis runs.

D-RAM: Displays the result of the access to the D-RAM (OK/NG). If NG, replace the audio unit - Refer to: Audio Unit Removal and Installation(With Normal Audio), or Audio Unit Removal and Installation(With Display Audio (7-inch Screen)), or Audio Unit Removal and Installation(With Color Audio (5-inch Screen)) .
Model: For this model, the field should begin with T5R.
Serial No. : Displays the audio unit serial number. That should be the same as the serial number found on the upper side of the audio unit.
Flash: Displays the result of the access to the flash memory (OK/NG). If NG, replace the audio unit - Refer to: Audio Unit Removal and Installation(With Normal Audio), or Audio Unit Removal and Installation(With Display Audio (7-inch Screen)), or Audio Unit Removal and Installation(With Color Audio (5-inch Screen)) .

Courtesy of HONDA, U.S.A., INC.

F-CAN

NOTE: This diagnosis must have the engine running.

This diagnosis checks whether the audio unit has received specific F-CAN data. If F-CAN shows NO ERROR, an error is not detected between the F-CAN bus and the audio unit.

If F-CAN shows RX ERROR, replace the audio unit - Refer to: Audio Unit Removal and Installation(With Normal Audio), or Audio Unit Removal and Installation(With Display Audio (7-inch Screen)), or Audio Unit Removal and Installation(With Color Audio (5-inch Screen)) .
If F-CAN shows TIME OUT, There is a possibility that some items are NG (red icon). When all the items from each transmitting unit is NG, check for F-CAN DTCs with the HDS. If DTCs not detected, check for continuity in the F-CAN lines between the audio unit and the transmitting unit.

NOTE: When the item is a variation equipment, the item shows NG (yellow icon), and it is not reflected in diagnosis.

Courtesy of HONDA, U.S.A., INC.

B-CAN

NOTE: This diagnosis must have the engine running.

This diagnosis checks whether the audio unit has received specific B-CAN data. If B-CAN shows NO ERROR, an error is not detected between the B-CAN bus and the audio unit.

If B-CAN shows RX ERROR, replace the audio unit - Refer to: Audio Unit Removal and Installation(With Normal Audio), or Audio Unit Removal and Installation(With Display Audio (7-inch Screen)), or Audio Unit Removal and Installation(With Color Audio (5-inch Screen)) .
If B-CAN shows TIME OUT, There is a possibility that some items are NG (red icon). When all the items from each transmitting unit is NG, check for B-CAN DTCs with the HDS. If DTCs not detected, check for continuity in the B-CAN lines between the audio unit and the transmitting unit.

NOTE: When the item is a variation equipment, the item shows NG (yellow icon), and it is not reflected in diagnosis.

Item	Transmitting Unit
VSPNE, AT, ILLUMI, VINNO, STRG_ANG, ODO_TRIP, TRICOM1 - 4, METER_RMD, GUIDE_INFO	Gauge control module

Courtesy of HONDA, U.S.A., INC.

USB

This diagnosis displays the USB device status that is connected to the audio unit.

If the USB memory device is connected to the USB port, the screen displays the USB controller status, the Bus power status, and the device status.

When you connect a USB mass storage device, you can see the capacity used and the amount of free space available.

Courtesy of HONDA, U.S.A., INC.

This diagnosis checks the SD card status.

Connection Status (A): Displays the result of the insert status about the SD card (OK; Inserted, NG; Not Inserted).
Access Status: Displays the result of the access to the SD card (OK/NG). If NG, replace the SD card , and recheck.

Courtesy of HONDA, U.S.A., INC.

Vehicle Status

Use this screen to confirm that the audio unit is properly receiving input signals. The displayed value changes each time according to the state of input signal.

NOTE: These items describe in indication order.

Item	Input	Description
BACK	BACK LT line	1: When the transmission is shifted to R position/mode 0: When the transmission is shifted to any position/mode other than R position/mode
IG	B-CAN lines	1: When the vehicle is in ON mode 0: When vehicle is in ACCESSORY mode
ILL	B-CAN lines	1: When parking lights, or headlights are on 0: When parking lights, or headlights are off
ILL CANCEL	B-CAN lines	1: When the dashlights brightness control knob is more than 90 % brightness with the parking lights turned on 0: When the dashlights brightness control knob is less than 90 % brightness with the parking lights turned on
ILL STEP	B-CAN lines	With the parking lights on, use the dashlights brightness control knob to dim and brighten the gauge. The value changes from 1 (max low) to 22 (max high).
Speed	B-CAN lines	This item indicates the vehicle speed (km/h).
PARK-VIDEO	PARKING BRAKE SW line	1: When the parking brake is applied 0: When the parking brake is not applied
PARK	B-CAN lines	1: When the parking brake is applied 0: When the parking brake is not applied
Current received VIN	B-CAN lines	This item indicates the VIN that received from the PCM.
Initial registered VIN	B-CAN lines	This item indicates the initial registration VIN that is saved in the audio unit.
Last registered VIN	B-CAN lines	This item indicates the additional registration VIN when the audio unit is substituted into another vehicle, or when a PCM is substituted or replaced into this vehicle.

Courtesy of HONDA, U.S.A., INC.

HFT/Mic

This diagnosis allows you to independently test the Bluetooth module and microphone. The Bluetooth module and the microphone are built into the audio panel. To properly check the microphones, make sure you are sitting in the driver's seat.

If the Bluetooth Connection Diagnosis shows NG, replace the audio panel - Refer to: Audio Unit Removal and Installation(With Normal Audio), or Audio Unit Removal and Installation(With Display Audio (7-inch Screen)), or Audio Unit Removal and Installation(With Color Audio (5-inch Screen)) . Press the TALK button, and in a normal voice say "testing" within 5 seconds. The Mic Level indicator on the screen should momentarily turn green. If there is no Mic Level movement when you speak, go to HFL does not respond troubleshooting - Refer to: HandsFreeLink System Symptom Troubleshooting - HFL does not respond(With Normal Audio), or HandsFreeLink System Symptom Troubleshooting - HFL does not respond(With Navigation), or HandsFreeLink System Symptom Troubleshooting - HFL does not respond(With Display Audio (7-inch Screen), Without Navigation), or HandsFreeLink System Symptom Troubleshooting - HFL does not respond(With Color Audio (5-inch Screen)) .

Courtesy of HONDA, U.S.A., INC.

If you select the Transmitter Volume Change icon, the transmitter volume can be selected from three selection (Large, Middle, Small).

Courtesy of HONDA, U.S.A., INC.

Hard Key

This diagnosis checks the audio unit hard buttons, face switches (AUDIO, HOME, MENU, VOL+, VOL-, BACK), the audio remote switch, and the HFL switch.

To complete the test, press each buttons. As each function is tested, the corresponding button on the display should highlight.

If any button of the audio unit does not respond, replace the audio panel or the audio unit - Refer to: Audio Unit Removal and Installation(With Normal Audio), or Audio Unit Removal and Installation(With Display Audio (7-inch Screen)), or Audio Unit Removal and Installation(With Color Audio (5-inch Screen)) .
If any button of the audio remote switch does not respond, do the audio remote switch test .
If any button of the HFL switch does not respond, do the HFL switch test .

Courtesy of HONDA, U.S.A., INC.

Error History

If you select Hard Error or Soft Error, you can see the error information. Refer to How to Check for Error History to use this diagnosis - Refer to: How to Troubleshoot the Audio System, or Audio System Self-Diagnostic Function .

Courtesy of HONDA, U.S.A., INC.

Rear Wide Camera

This diagnosis checks the rearview camera connection.

If Connection shows NG, check for hard error codes - Refer to: How to Troubleshoot the Audio System, or Audio System Self-Diagnostic Function .
If Connection shows OK, press the HOME button to display the rearview camera image. To return to the previous screen, press the HOME button again.

Courtesy of HONDA, U.S.A., INC.

LaneWatch

This diagnosis checks the LaneWatch camera connection.

If Connection shows NG, check for hard error codes - Refer to: How to Troubleshoot the Audio System, or Audio System Self-Diagnostic Function .
If Connection shows OK, press the HOME button to display the LaneWatch camera image. To return to the previous screen, press the HOME button again.

Courtesy of HONDA, U.S.A., INC.

Radio

This diagnosis displays the radio tuner status.

NOTE: When the radio tuner is built in the audio unit, a diagnostic result is displayed as always OK.

Frequency can be changed by selecting each icon (A).
Source can be changed in this order: AM→FM by selecting the Band Change icon.
Electric Field Intensity displays radio reception sensitivity (dBμV).

Courtesy of HONDA, U.S.A., INC.

Display

This diagnosis checks the display controller. In this model, OK is always indicated.

Courtesy of HONDA, U.S.A., INC.

A/C

This diagnosis detects if the vehicle is in ON mode using information provided over the F-CAN bus, then it tests the climate control signal via the B-CAN bus between the audio unit and the climate control unit. Make sure the engine is running for this test.

If Connection shows NG, check for hard error codes - Refer to: How to Troubleshoot the Audio System, or Audio System Self-Diagnostic Function .