DTC U3003-17 (EPS Control Unit)

DTC U3003-17: Battery Voltage High

NOTE

Initial Diagnosis:
The initial on-board diagnosis occurs right after the vehicle condition is turned to the ON mode, and the EPS indicator comes on, and continues until the indicator goes off.
Regular Diagnosis:
The regular on-board diagnosis begins right after the EPS indicator goes off, and it continues until the vehicle condition is turned to the OFF (LOCK) mode.
Review "How to troubleshoot the EPS" before doing the DTC troubleshooting procedure.
Test-drive the vehicle according to local traffic conditions and regulations. Do not test-drive on a lift unless specified.
The possible causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.

Confirmation Procedure	Basic Condition: While an engine is running Operating Condition: Turn the vehicle to the READY TO DRIVE mode. Turn the vehicle to the OFF (LOCK) mode. Turn the vehicle to the READY TO DRIVE mode.
Execution	Regular Diagnosis
Duration	About 1 second
DTC Type	1 drive cycle EPS indicator on
Fail Safe Action	Continue EPS function/assist (Fade out) (Continue system diagnosis: EPS function/assist will return to normal when the 12 volt battery voltage is less than 18.2 V)
Possible Cause	Electric powertrain system failure EPS motor/control unit internal failure