Engine Oil Pump Removal and Installation: Installation

NOTE:  Where icon is shown for further information continue to the information below.

Fig 1: Engine Oil Pump Bolts With Torque Specifications

Courtesy of HONDA, U.S.A., INC.

	Detailed information, notes, and precautions
	Torque: N.m (kgf.m, lbf.ft)
	Replace

1. Oil Pump - Install

   1. Apply liquid gasket to the engine block mating surface of the oil pump and to the inside edge of the threaded bolt holes. 2. Align the inner rotor with the crankshaft, and install the oil pump. NOTE: Replace the pulley end crankshaft oil seal as needed. 3. Clean the excess oil off the crankshaft, and check that the oil seal lip is not distorted.

2. Oil Strainer - Install
3. Oil Filter Base/Oil Filter Assembly - Install
4. Oil Pan - Install
5. Engine - Support

   1. Lift and support the engine with a jack and a wood block under the oil pan.

6. Engine Support Hanger - Remove

   NOTE:  After removing the engine support hanger, install the front damper caps.

7. Cowl Cover - Install
8. Connector (Rocker Arm Oil Pressure Sensor) - Connect
9. Timing Belt Drive Pulley - Install
10. Timing Belt - Install
11. Engine Oil - Refill
12. Air Guide and Air Intake Duct - Install 
13. Front Bulkhead Cover - Install
14. Engine Cover - Install