Specifications Index

COMMON SPECS & PROCEDURES INDEX

System		Specification/Procedure
Air Conditioning
Service		AIR CONDITIONING
Torque		HEATING, VENTILATION, AND AIR CONDITIONING
Axle Nut/Hub Nut
Front 328 N.m (242 ft. lbs.) Rear 245 N.m (181 lbf.ft)
Battery		12 VOLT BATTERY SENSOR REMOVAL AND INSTALLATION
Brakes
Bleeding Sequence		CONVENTIONAL BRAKE SYSTEM BLEEDING
Disc Brakes		FRONT BRAKE DISC REMOVAL AND INSTALLATION or REAR BRAKE DISC REMOVAL AND INSTALLATION
Torque		BRAKES
Charging
Service Specifications		ELECTRICAL SYSTEM - SERVICE INFORMATION
Torque		ENGINE ELECTRICAL
Drive Belts
Belt Routing & Adjustment		DRIVE BELT REMOVAL AND INSTALLATION
Engine Cooling
General Service Specifications		COOLING SYSTEM
Radiator Cap Pressure		93-123 kPa (0.95-1.25 kgf/cm2, 13.5-17.8 psi)
Thermostat R & I		THERMOSTAT REMOVAL, INSTALLATION, AND TEST
Water Pump R & I		WATER PUMP REMOVAL AND INSTALLATION
Engine Mechanical
Compression		930 kPa (9.48 kgf/cm² , 134.8 psi) Minimum 200 kPa (2.04 kgf/cm² , 29.0 psi) Maximum variation
Oil Pressure (176°F (80°C)		70 kPa (0.71 kgf/cm² , 10.2 psi) min. @ idle 490 kPa (5.00 kgf/cm² , 71.1 psi) min. @ 3000 RPM
Overhaul		See applicable specifications tables in ENGINE MECHANICAL SERVICE SPECIFICATIONS
Torque		ENGINE MECHANICAL
Fluid Specifications		See FLUIDS under MAINTENANCE tab.
Flywheel/Flex Plate Torque		74 N.m (55 ft. lbs.)
Fuel System
Pressure Specification		410 - 460 kPa (4.18 - 4.69 kgf/cm 2, 59.5 - 66.7 psi)
Fuel Pressure Test Procedure		FUEL PRESSURE TEST
Ignition
Firing Order & Cylinder Identification		FIRING ORDER & CYLINDER IDENTIFICATION
Spark Plug NGK: 7751
Gap		1.0-1.1 mm (0.039-0.043 in)
Torque		22 N.m (16 ft. lbs.)
Starting
Starter		ENGINE ELECTRICAL SERVICE SPECIFICATIONS
Torque		ENGINE ELECTRICAL
Wheel Alignment
Adjustment Specifications		WHEEL ALIGNMENT
	Torque	SUSPENSION
Wheel & Tire
Wheel Lug Nut Torque		127 N.m (94 ft. lbs.)