Keyless Buzzer Circuit Troubleshooting
Keyless Buzzer Circuit Troubleshooting
- Open wire check (GND line)
-1. Turn the vehicle to the OFF (LOCK) mode.
-2. Disconnect the following connector.
Keyless buzzer 3P connector -3. Check for continuity between test points 1 and 2.
Test condition Vehicle OFF (LOCK) modeKeyless buzzer 3P connector: disconnected Test point 1 Keyless buzzer 3P connector (female terminals) No. 3: Test point 2 Body ground Is there continuity?
YES
The GND wire is OK. Go to step 2.
NO
Repair an open or high resistance in the ground wire or poor ground (G505 (except japan production) / G506 (japan production)).
- Open wire check (SMART BUZZER line)
-1. Disconnect the following connector.
Body control module connector E (24P) -2. Check for continuity between test points 1 and 2.
Test condition Vehicle OFF (LOCK) modeKeyless buzzer 3P connector: disconnectedBody control module connector E (24P): disconnected Test point 1 Body control module connector E (24P) No. 22 Test point 2 Keyless buzzer 3P connector (female terminals) No. 2: Is there continuity?
YES
The SMART BUZZER wire is not open. Go to step 3.
NO
Repair an open or high resistance in the wire.
- Shorted wire check (SMART BUZZER line)
-1. Remove the jumper wire from the keyless buzzer 3P connector.
-2. Check for continuity between test points 1 and 2.
Test condition Vehicle OFF (LOCK) modeKeyless buzzer 3P connector: disconnectedBody control module connector E (24P): disconnected Test point 1 Body control module connector E (24P) No. 22 Test point 2 Body ground Is there continuity?
YES
Repair a short to ground in the wire.
NO
The SMART BUZZER wire is OK. Go to step 4.
- Keyless buzzer check (substitution)
-1. Substitute a known-good keyless buzzer .
-2. Check the keyless buzzer function.
Does the keyless buzzer sound?
YES
Replace the original keyless buzzer .
NO