Idle Stop Off Switch Removal, Installation, and Test (With Auto Idle Stop System) (2020 2021): Test

Idle Stop Off Switch - Test

Courtesy of HONDA, U.S.A., INC.

Contact point - Test

1. Check for continuity between idle stop off switch connector terminals according to the table.

If the result is not normal, replace the Idle stop off switch.

Connector
Idle stop off switch 5P connector (male terminals):
Test terminal	Switch position	Normal
No. 1 - No. 3	pressed	continuity
No. 1 - No. 3	not pressed	not continuity

Courtesy of HONDA, U.S.A., INC.

LED - Test

NOTE:

When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.
Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction.

2. Connect the 12 volt battery to the Idle stop off switch according to the table.

3. Check that the LED of the idle stop off switch comes on.If the LED does not come on, replace the idle stop off switch.

Connector
Idle stop off switch 5P connector (male terminals):
Terminal	12 volt battery
No. 4	+
No. 5	-