DTC B1085
DTC B1085 : Head light low light source abnormality
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A
.
| DTC Description | DTC |
|---|---|
| B1085 Head light low light source abnormality |
DTC (Body Control Module)
- Problem verification 1
-1. Clear the DTCs with the HDS.
-2. Turn the combination light switch to the ON position.
-3. Check for DTCs with the HDS.
DTC Description DTC B1085 Head light low light source abnormality Is DTC B1085 indicated?
YES
Go to step 2.
NO
Intermittent failure, the system is OK at this time.
- Headlight operation check
-1. Check the status of the headlights (low beam).
Does one of headlights go off?
YES
Go to step 3.
NO
Go to step 4.
- Headlight check
-1. Swap the left headlight and the right headlight.
Are the symptoms swapped left and right?
YES
Replace the failure headlight .
NO
- Shorted wire check (H/L LO SIG line)
-1. Turn the vehicle to the OFF (LOCK) mode.
-2. Disconnect the following connectors.
Body control module connector D (40P)
Right headlight 8P connector
Left headlight 8P connector-3. Check for continuity between test points 1 and 2.
Test condition Vehicle OFF (LOCK) mode
Body control module connector D (40P): disconnected
Right headlight 8P connector: disconnected
Left headlight 8P connector: disconnectedTest point 1 Body control module connector D (40P) No. 16 Test point 2 Body ground Is there continuity?
YES
Repair a short to ground in the wire.
NO