DTC P0106
DTC P0106 : MAP Sensor Range/Performance Problem
| DTC Description | Confirmed DTC | Pending DTC |
|---|---|---|
| P0106 MAP Sensor Range/Performance Problem |
DTC (PGM-FI)
- Parts condition check:
Check for poor connections or damage to these parts:
- PCV hose
- Purge (PCS) line
- Air cleaner
- Intake air duct
- Intake manifold
- Throttle body
Are the parts OK?
YES
Go to step 2.
NO
Repair or replace the damaged part(s).
- MAP sensor visual check
-1. Remove the MAP sensor .
-2. Check the MAP sensor port for clogging or restrictions (foreign material, carbon or sludge, etc.).
Is the MAP sensor port clogged or restricted?
YES
Remove the clog or restriction from the MAP sensor.
NO
Reinstall the MAP sensor , then go to step 3.
- Problem verification 1
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode.
-4. Turn the vehicle to the ON mode.
-5. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC P0106 MAP Sensor Range/Performance Problem DTC (PGM-FI)
Is DTC P0106 indicated?
YES
The failure is duplicated. Replace the MAP sensor .
NO
Go to step 4.
- Problem verification 2
-1. Enter the maintenance mode, then start the engine .
-2. Hold the engine speed at 3, 000 RPM without load (in P or N) until the radiator fan comes on, then let it idle.
-3. Test-drive under these conditions:
- Engine coolant temperature (ECT SENSOR 1) above 158 deg.F (70 deg.C)
- Transmission in D
- Vary the engine speed between 1, 100-5, 500 RPM, and drive the vehicle at around 40 mph (60 km/h) for 5 seconds
Signal Current conditions Values Unit ECT Sensor 1 Engine Speed Vehicle Speed Data List
-4. Monitor the OBD STATUS for DTC P0106 in the DTCs MENU with the HDS.
DTC Description OBD STATUS P0106 MAP Sensor Range/Performance Problem OBD Status
Does the HDS indicate FAILED?
YES
The failure is duplicated. Replace the MAP sensor .
NO
If the HDS indicates PASSED, intermittent failure, the system is OK at this time. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot . If the HDS indicates NOT COMPLETED, go to step 4-3 and recheck.