Throttle Body Removal and Installation: Installation

WARNING:

Do not insert your fingers into the installed throttle body when you press the engine start/stop button to select the ON mode, or while the vehicle is in the ON mode. If you do, you will seriously injure your fingers if the throttle valve is activated.

Throttle Body - Install
1. Install the throttle body (A) with a new gasket (B).

Fig 1: Throttle Body Exploded View With Torque Specifications
Courtesy of HONDA, U.S.A., INC.

2. Tighten the bolts (C) in a cross pattern in three steps; tighten the bolts until the bolts sit on the throttle body, tighten the bolts until the gasket is compressed and both parts are contacted, tighten the bolts to specified torque.

3. Connect the water bypass hoses (D) to the throttle body.

4. Connect the throttle body connector (E).

5. Install the intake air duct (F).

6. Install the EVAP canister purge valve (G) with a new O-ring (H), then connect the connector (I).

7. Connect the vacuum hose (J) to the EVAP canister purge valve.
Air Cleaner - Install
Engine Coolant - Refill
PCM - Reset
PCM - Idle Learn