Specifications Index

COMMON SPECS & PROCEDURES INDEX

System		Specification/Procedure
Air Conditioning
Service		AIR CONDITIONING - SERVICE SPECIFICATIONS
Torque		HEATING, VENTILATION, AND AIR CONDITIONING
Axle Nut/Hub Nut
Front 328 N.m (242 lbf.ft) Rear 181 N.m (133 lbf.ft)
Battery		12 VOLT BATTERY REMOVAL AND INSTALLATION
Brakes
Bleeding Sequence		CONVENTIONAL BRAKE SYSTEM BLEEDING
Disc Brakes		BRAKE SYSTEM - SERVICE SPECIFICATIONS
Torque		BRAKES
Charging
Service Specifications		ENGINE ELECTRICAL SERVICE SPECIFICATIONS
Torque		ENGINE ELECTRICAL
Drive Belts
Belt Routing & Adjustment		DRIVE BELT REMOVAL AND INSTALLATION
Engine Cooling
General Service Specifications		ENGINE COOLING SYSTEM - SERVICE SPECIFICATIONS
Radiator Cap Pressure		93-123 kPa (0.95-1.25 kgf/cm2, 13.5-17.8 psi)
Thermostat R & I		THERMOSTAT REMOVAL, INSTALLATION, AND TEST ,
Water Pump R & I		WATER PUMP REMOVAL AND INSTALLATION
Engine Mechanical
Compression		880 kPa (8.97 kgf/cm² , 127.6 psi) Minimum 200 kPa (2.04 kgf/cm² , 29.0 psi) Maximum variation
Oil Pressure (176°F (80°C)		106 kPa (1.08 kgf/cm² , 15.4 psi) min. @ idle 373 kPa (3.80 kgf/cm² , 54.0 psi) min. @ 2000 RPM
Overhaul		See applicable specifications tables in ENGINE MECHANICAL - SERVICE SPECIFICATIONS
Torque		ENGINE MECHANICAL
Fluid Specifications		See FLUIDS under MAINTENANCE tab.
Flywheel/Flex Plate Torque		74 N.m (55 ft. lbs.)
Fuel System
Pressure Specification		390 - 440 kPa (3.98 - 4.49 kgf/cm 2, 56.6 - 63.8 psi)
Fuel Pressure Test Procedure		FUEL PRESSURE TEST
Ignition
Firing Order & Cylinder Identification		FIRING ORDER & CYLINDER IDENTIFICATION
Spark Plug NGK: 7751
Gap		1.0-1.1 mm (0.039-0.043 in)
Torque		22 N.m (16 ft. lbs.)
Starting
Starter		ENGINE ELECTRICAL SERVICE SPECIFICATIONS
Torque		ENGINE ELECTRICAL
Wheel Alignment
Adjustment Specifications		SUSPENSION - SERVICE SPECIFICATIONS
	Torque	SUSPENSION
Wheel & Tire
Wheel Lug Nut Torque		108 N.m (80 ft. lbs.)