| Cannot select ON mode with keyless access and with the keyless remote touching the engine start/stop switch |
- Poor connections at the body control module
- Keyless remote
- Body control module
- Engine start/stop switch
- Harness/connections
|
| Cannot select ON mode with keyless access, but can select ON mode with the keyless remote touching the engine start/stop switch |
- Body control module
- LF antenna
- Keyless remote
- Low or weak keyless remote battery
- Harness/connections
|
| Cannot select ON mode with the keyless remote touching the engine start/stop switch, but can select ON mode with keyless access |
Check the body control module |
- Body control module is not registered
- Body control module
- IGN TRX line open/short
- Harness/connections
|
| The mode changes between ACCESSORY and ON, but it does not change to OFF |
- Check the body control module
- Check the TCM
|
- Body control module
- ATP-P line open
- TCM
|
| The mode changes between ACCESSORY and ON, but it is difficult to change to OFF |
- Check the body control module
- Check the gauge control module
- Check the TCM
|
- Gauge control module
- Body control module
- PCM
- B-CAN communication line open/short
- F-CAN communication line open/short
- Speed signal line open
- TCM
|
| Engine start/stop switch does not work |
Check for DTCs. If any DTC is indicated, go to the DTC troubleshooting |
- ACC relay circuit
- Body control module
- Engine start/stop switch
- SS1(+) line short
- SS2(-) line short
- Harness/connections
|
| Engine does not crank (power supply is normal) |
- Check the brake pedal position switch
- Check the body control module
|
- Body control module
- STS line open/short
- Brake pedal position switch
- STOP SW line open/short
|
| The engine starts, but stalls immediately |
- No power to PCM
- No power to body control module
- Body control module
- Gauge control module
- Harness/connections
|