Inspection Outline

• The components to be tested are indicated by a dotted line.

Courtesy of HONDA, U.S.A., INC.

• Troubleshoot any DTCs listed or indicated systems below first.
  • Keyless Access System [ Keyless Access Control Unit ], [ Backup Control Unit ], [ Power Control Unit ] : Go to the indicated DTC's troubleshooting .

For more efficient troubleshooting, you may be able to eliminate some inspection items as potential failures based on the conditions of the failure and vehicle.

• (Application 1) Do the HDS [ Self Check ]
  • The system communicate with the HDS:
  • The system does not communicate with the HDS:

• (Application 2) Reboot the HDS and select YES when asked if the vehicle has keyless access system, this selects the forced ON mode
  • The system changes to forced ON mode:
  • The system does not change to forced ON mode:

Inspection Items		Work Items	Application 1		Application 2
a	Remote	Do the Keyless Access Remote Test	o	o	o	o
b	Engine Start/Stop Switch	Do the Engine Start/Stop Switch Test	o	o	o	o
c	External Circuit	+B_SMART, SS1 (+), SS2 (-), GND Circuit Inspection		o
		+B_BACK_UP, GND, +B_SMART Circuit Inspection	o	o		o
		+B_SMART, MTR_CONT, ESL_SW_B, ESL_SW_C, ESL_SW_D, MTR_CUT1 (CONT), MTR_CUT2 (IG1), ESL_PWR, IGN_TRX, GND Circuit Inspection (With Electric Steering Lock)	o	o		o
		L-LINE Circuit Inspection		o
d	Body Control Module	Body Control Module Inspection - Without Electric Steering Lock - With Electric Steering Lock	o	o	o	o
e	Electric Steering Lock *	Electric Steering Lock Inspection	o	o	o	o

*: With electric steering lock