CSS_5V, CSS_SIG1, CSS_SIG2, CSS_GND Circuit Inspection

Test Procedure 

• Preparation
• • -

    VSA modulator-control unit 46P connector: disconnected

  • -

    Clutch pedal stroke sensor 4P connector: disconnected

• Procedure
• • -

    Perform the inspection according to the following table.

		(Disconnected) VSA modulator-control unit 46P connector female terminals	(Disconnected) Clutch pedal stroke sensor 4P connector female terminals
	IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
CSS_5V open wire inspection	OFF			There is less than 1 Ω
CSS_SIG1 open wire inspection	OFF			There is less than 1 Ω
CSS_SIG2 open wire inspection	OFF			There is less than 1 Ω
CSS_GND open wire inspection	OFF			There is less than 1 Ω
Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.
CSS_5V shorted to ground inspection	OFF			Not shorted
CSS_SIG1 shorted to power inspection	ON			Not shorted
CSS_SIG2 shorted to power inspection	ON			Not shorted
CSS_SIG1 shorted to ground inspection	OFF			Not shorted
CSS_SIG2 shorted to ground inspection	OFF			Not shorted

Results 

• If abnormal, there is a problem in the circuit.