DTC B1042 (Body Control Module): Inspection

BACK_UP(WIPER) Circuit Inspection 

Test Procedure 

• Preparation
  • Windshield wiper control unit/motor connector (5P): disconnected
  • Body control module connector A (66P): disconnected
• Procedure
  • Perform the inspection according to the following chart.

			(Disconnected) Windshield wiper control unit/motor connector (5P) female terminals	(Disconnected) Body control module connector A (66P) female terminals
		IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
	BACK_UP(WIPER) open wire inspection	OFF			There is less than 1 Ohms
	Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.
	BACK_UP(WIPER) shorted to ground inspection	OFF			There is more than 1 MOhms

Results 

• If abnormal, there is a problem in the circuit.
• If normal, there is a problem with the windshield wiper control unit/motor.