APP Sensor Signal Inspection: Inspection
How to use this service information .
NOTE:
Check for Pending or Confirmed DTCs with the HDS before doing this procedure. If any DTCs are indicated, troubleshoot them first, then do this procedure.
NOTE:
- This procedure checks the APP sensor in its fully closed position. In any other position, the PCM stores the APP sensor DTCs which are covered in other troubleshooting procedures.
- Press the accelerator pedal several times to check its operation. If it does not operate smoothly, check the pedal. If you find a problem, replace the accelerator pedal module .
- APP Sensor Signal - Inspect
Preconditions
Procedure/Specifications
- Select the following menu buttons on the HDS screen in sequence.NOTE:
Make sure the accelerator pedal is not pressed.
-
- PGM-FI (System Selection Menu)
- Data List
- APP Sensor
Specifications
HDS Item Specification APP Sensor 0 % Result
- If the measurement is not within specifications, update the PCM to the latest software - Refer to: PCM Update or PCM Reset or substitute a known-good PCM , then recheck. If the recheck result is abnormal, replace the accelerator pedal module , and recheck.
- Select the following menu buttons on the HDS screen in sequence.