Keyless/Power Door Locks/Security System Symptom Troubleshooting - Security alarm system will not arm: Inspection

HOOD_SW, HOOD_SW_2, GND Circuit Inspection

Test Procedure

Preparation
- Left/Right hood latch switch connector (2P): disconnected
- Relay control module connector C (18P): disconnected
Procedure
- Perform the inspection according to the following chart.


		(Disconnected) Left hood latch switch connector (2P) female terminals	(Disconnected) Relay control module connector C (18P) female terminals
	IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
HOOD_SW open wire inspection	OFF			There is less than 1 Ohms
Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.
HOOD_SW shorted to ground inspection	OFF			There is more than 1 MOhms

		(Disconnected) Right hood latch switch connector (2P) female terminals	(Disconnected) Left hood latch switch connector (2P) female terminals
	IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
HOOD_SW_2 open wire inspection	OFF			There is less than 1 Ohms
GND open wire inspection	OFF			There is less than 1 Ohms
Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.
HOOD_SW_2 shorted to ground inspection	OFF			There is more than 1 MOhms

Results

If abnormal, there is a problem in the circuit.

FL_DOOR_SW, GND Open Wire Inspection

Test Procedure

Preparation
- Driver's door latch connector (10P): disconnected
- Body control module connector B (66P): disconnected
Procedure
- Perform the inspection according to the following chart.


			(Disconnected) Driver's door latch connector (10P) female terminals	(Disconnected) Body control module connector B (66P) female terminals

	IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
FL_DOOR_SW open wire inspection	OFF			There is less than 1 Ohms
GND open wire inspection	OFF			There is less than 1 Ohms

Results

If abnormal, there is a problem in the circuit.

DR_SILCON_UNLOCK, GND Circuit Inspection

Test Procedure

Preparation
- Driver's door latch connector (10P): disconnected
- Driver's door control unit connector C (32P): disconnected
Procedure
- Perform the inspection according to the following chart.


		(Disconnected) Driver's door latch connector (10P) female terminals	(Disconnected) Driver's door control unit connector C (32P) female terminals
	IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
DR_SILCON_UNLOCK open wire inspection	OFF			There is less than 1 Ohms
GND open wire inspection	OFF			There is less than 1 Ohms
Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.
DR_SILCON_UNLOCK shorted to ground inspection	OFF			There is more than 1 MOhms

Results

If abnormal, there is a problem in the circuit.

DR_KEY_CYL_LOCK, GND Circuit Inspection

Test Procedure

Preparation
- Driver's door latch connector (10P): disconnected
- Driver's door control unit connector C (32P): disconnected
Procedure
- Perform the inspection according to the following chart.


		(Disconnected) Driver's door latch connector (10P) female terminals	(Disconnected) Driver's door control unit connector C (32P) female terminals
	IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
DR_KEY_CYL_LOCK open wire inspection	OFF			There is less than 1 Ohms
GND open wire inspection	OFF			There is less than 1 Ohms
Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.
DR_KEY_CYL_LOCK shorted to ground inspection	OFF			There is more than 1 MOhms

Results

If abnormal, there is a problem in the circuit.

FR_DOOR_SW, GND Open Wire Inspection

Test Procedure

Preparation
- Front passenger's door latch connector (10P): disconnected
- Body control module connector B (66P): disconnected
Procedure
- Perform the inspection according to the following chart.


		(Disconnected) Front passenger's door latch connector (10P) female terminals	(Disconnected) Body control module connector B (66P) female terminals
	IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
FR_DOOR_SW open wire inspection	OFF			There is less than 1 Ohms
GND open wire inspection	OFF			There is less than 1 Ohms

Results

If abnormal, there is a problem in the circuit.

AS_SILCON_UNLOCK, GND Circuit Inspection

Test Procedure

Preparation
- Front passenger's door latch connector (10P): disconnected
- Front passenger's door control unit connector C (32P): disconnected
Procedure
- Perform the inspection according to the following chart.

		(Disconnected) Front passenger's door latch connector (10P) female terminals	(Disconnected) Front passenger's door control unit connector C (32P) female terminals
	IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
AS_SILCON_UNLOCK open wire inspection	OFF			There is less than 1 Ohms
GND open wire inspection	OFF			There is less than 1 Ohms
Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.
AS_SILCON_UNLOCK shorted to ground inspection	OFF			There is more than 1 MOhms

Results

If abnormal, there is a problem in the circuit.

RL_DOOR_SW, SGND Open Wire Inspection

Test Procedure

Preparation
- Left rear door latch connector (10P): disconnected
- Body control module connector B (66P): disconnected
Procedure
- Perform the inspection according to the following chart.


			(Disconnected) Left rear door latch connector (10P) female terminals	(Disconnected) Body control module connector B (66P) female terminals

	IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
RL_DOOR_SW open wire inspection	OFF			There is less than 1 Ohms
SGND open wire inspection	OFF			There is less than 1 Ohms

Results

If abnormal, there is a problem in the circuit.

RR_L_SILCON_UNLOCK, SGND Circuit Inspection

Test Procedure

Preparation
- Left rear door latch connector (10P): disconnected
- Body control module connector B (66P): disconnected
Procedure
- Perform the inspection according to the following chart.


		(Disconnected) Left rear door latch connector (10P) female terminals	(Disconnected) Body control module connector B (66P) female terminals
	IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
RR_L_SILCON_UNLOCK open wire inspection	OFF			There is less than 1 Ohms
SGND open wire inspection	OFF			There is less than 1 Ohms
Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.
RR_L_SILCON_UNLOCK shorted to ground inspection	OFF			There is more than 1 MOhms

Results

If abnormal, there is a problem in the circuit.

RR_DOOR_SW, SGND Open Wire Inspection

Test Procedure

Preparation
- Right rear door latch connector (10P): disconnected
- Body control module connector B (66P): disconnected
Procedure
- Perform the inspection according to the following chart.


		(Disconnected) Right rear door latch connector (10P) female terminals	(Disconnected) Body control module connector B (66P) female terminals
	IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
RR_AS_DOOR_SW open wire inspection	OFF			There is less than 1 Ohms
SGND open wire inspection	OFF			There is less than 1 Ohms

Results

If abnormal, there is a problem in the circuit.

RR_R_SILCON_UNLOCK, SGND Circuit Inspection

Test Procedure

Preparation
- Right rear door latch connector (10P): disconnected
- Body control module connector B (66P): disconnected
Procedure
- Perform the inspection according to the following chart.


		(Disconnected) Right rear door latch connector (10P) female terminals	(Disconnected) Body control module connector B (66P) female terminals
	IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
RR_R_SILCON_UNLOCK open wire inspection	OFF			There is less than 1 Ohms
SGND open wire inspection	OFF			There is less than 1 Ohms
Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.
RR_R_SILCON_UNLOCK shorted to ground inspection	OFF			There is more than 1 MOhms

Results

If abnormal, there is a problem in the circuit.

Relay Control Module Inspection

NOTE: Since there is no direct method to test the inspection item, troubleshooting is performed using a known-good component.

Test Procedure

Install a known-good relay control module and attempt to reproduce the failure.

Results

If the failure is reproduced, there is a problem with other related components.
If the symptom/DTC goes away, the relay control module must be faulty.

Body Control Module Inspection

Test Procedure

If the other inspection item(s) indicated a normal condition, then it is determined that the remaining body control module is the cause.

Results

There is a problem with the body control module.