DTC B12F3 (Keyless Access Power Control Unit): Inspection
+B_TCU [VB1], +B_TCU2 [VB2], +B_TCU3 [VB3], IG1_TCU [IG1], GND [LG1], GND [LG2], IGN_TRX [IGNTRx] Circuit Inspection
Test Procedure
- Preparation
- TCM connector A (23P): disconnected
- Body control module connector C (66P): disconnected
- Procedure
- Perform the inspection according to the following table.
| (Disconnected) TCM connector A (23P) female terminals | (Disconnected) Body control module connector C (66P) female terminals | ||||
| IG Mode |
|
|
Normal Conditions | ||
| +B_TCU [VB1] circuit inspection | OFF | 12 V battery voltage[circuit type 1] | |||
| +B_TCU2 [VB2] circuit inspection | OFF | 12 V battery voltage[circuit type 1] | |||
| +B_TCU3 [VB3] circuit inspection | OFF | 12 V battery voltage [circuit type 1] | |||
| IG1_TCU [IG1] circuit inspection | ON | 12 V battery voltage [circuit type 3] | |||
| GND [LG1] open wire inspection | OFF | There is less than 1 Ohms | |||
| GND [LG2] open wire inspection | OFF | There is less than 1 Ohms | |||
| IGN_TRX [IGNTRx] open wire inspection | OFF | There is less than 1 Ohms | |||
| IGN_TRX [IGNTRx] shorted to ground inspection | OFF | There is more than 1 MOhms |
Results
- If abnormal, there is a problem in the circuit.
If the power supply inspection of the above table showed abnormally, do the additional Power Supply Inspection , to locate the failure.
TCM Inspection
NOTE: Since there is no direct method to test the inspection item, troubleshooting is performed using a known-good component.
Test Procedure
- Install a known-good TCM and attempt to reproduce the failure.
Results
- If the failure is reproduced, there is a problem with other related components.
- If the symptom/DTC goes away, the TCM must be faulty.
Body Control Module Inspection
Test Procedure
- If the other inspection item(s) indicated a normal condition, then it is determined that the remaining body control module is the cause.
Results
- There is a problem with the body control module.