Keyless Access System Symptom Troubleshooting - Cannot select ON mode with keyless access, but can select ON mode with the keyless remote touching the engine start/stop switch: Inspection

SS1(+), SS2(-) Open Wire Inspection 

Test Procedure 

• Preparation
  • Engine start/stop switch connector (10P): disconnected
  • Body control module connector C (66P): disconnected
• Procedure
  • Perform the inspection according to the following chart.

			(Disconnected) Engine start/stop switch connector (10P) female terminals	(Disconnected) Body control module connector C (66P) female terminals
		IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
	SS1(+) open wire inspection	OFF			There is less than 1 Ohms
	SS2(-) open wire inspection	OFF			There is less than 1 Ohms

Results 

• If abnormal, there is a problem in the circuit.

Body Control Module Inspection 

Test Procedure 

• If the other inspection item(s) indicated a normal condition, then it is determined that the remaining body control module is the cause.

Results 

• There is a problem with the body control module.