Keyless Access System Touch Sensor Circuit Troubleshooting: Inspection

VOUT_FR_DR, TS_FR_DR, DL_FR_DR, GND Circuit Inspection 

Test Procedure 

• Preparation
  • Driver's door control unit connector C (32P): disconnected
  • Driver's door outer handle connector (4P): disconnected
  • Body control module connector C (66P): disconnected
• Procedure
  • Perform the inspection according to the following chart.

			(Disconnected) Driver's door outer handle connector (4P) male terminals	(Disconnected) Driver's door control unit connector C (32P) female terminals

		IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
	VOUT_FR_DR open wire inspection	OFF			There is less than 1 Ohms
	Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.
	VOUT_FR_DR shorted to ground inspection	OFF			There is more than 1 MOhms

			(Disconnected) Driver's door outer handle connector (4P) male terminals	(Disconnected) Body control module connector C (66P) female terminals
		IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
	TS_FR_DR open wire inspection	OFF			There is less than 1 Ohms
	DL_FR_DR open wire inspection	OFF			There is less than 1 Ohms
	GND open wire inspection	OFF			There is less than 1 Ohms
	Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.
	TS_FR_DR shorted to ground inspection	OFF			There is more than 1 MOhms
	DL_FR_DR shorted to ground inspection	OFF			There is more than 1 MOhms

Results 

• If it is abnormal, there is a problem in the circuit.

VOUT_FR_AS, TS_FR_AS, DL_FR_AS, GND Circuit Inspection 

Test Procedure 

• Preparation
  • Front passenger's door outer handle connector (4P): disconnected
  • Body control module connector C (66P): disconnected
• Procedure
  • Perform the inspection according to the following chart.

			(Disconnected) Front passenger's door outer handle connector (4P) male terminals	(Disconnected) Body control module connector C (66P) female terminals
		IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
	VOUT_FR_AS open wire inspection	OFF			There is less than 1 Ohms
	TS_FR_AS open wire inspection	OFF			There is less than 1 Ohms
	DL_FR_AS open wire inspection	OFF			There is less than 1 Ohms
	GND open wire inspection	OFF			There is less than 1 Ohms
	Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.
	VOUT_FR_AS shorted to ground inspection	OFF			There is more than 1 MOhms
	TS_FR_AS shorted to ground inspection	OFF			There is more than 1 MOhms
	DL_FR_AS shorted to ground inspection	OFF			There is more than 1 MOhms

Results 

• If it is abnormal, there is a problem in the circuit.

VOUT_RR_L, TS_RR_L, DL_RR_L, SGND Circuit Inspection 

Test Procedure 

• Preparation
  • Left rear door outer handle connector (4P): disconnected
  • Body control module connector C (66P): disconnected
• Procedure
  • Perform the inspection according to the following chart.

			(Disconnected) Left rear door outer handle connector (4P) male terminals	(Disconnected) Body control module connector C (66P) female terminals
		IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
	VOUT_RR_L open wire inspection	OFF			There is less than 1 Ohms
	TS_RR_L open wire inspection	OFF			There is less than 1 Ohms
	DL_RR_L open wire inspection	OFF			There is less than 1 Ohms
	SGND open wire inspection	OFF			There is less than 1 Ohms
	Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.
	VOUT_RR_L shorted to ground inspection	OFF			There is more than 1 MOhms
	TS_RR_L shorted to ground inspection	OFF			There is more than 1 MOhms
	DL_RR_L shorted to ground inspection	OFF			There is more than 1 MOhms

Results 

• If it is abnormal, there is a problem in the circuit.

VOUT_RR_R, TS_RR_R, DL_RR_R, SGND Circuit Inspection 

Test Procedure 

• Preparation
  • Right rear door outer handle connector (4P): disconnected
  • Body control module connector C (66P): disconnected
• Procedure
  • Perform the inspection according to the following chart.

			(Disconnected) Right rear door outer handle connector (4P) male terminals	(Disconnected) Body control module connector C (66P) female terminals
		IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
	VOUT_RR_R open wire inspection	OFF			There is less than 1 Ohms
	TS_RR_R open wire inspection	OFF			There is less than 1 Ohms
	DL_RR_R open wire inspection	OFF			There is less than 1 Ohms
	SGND open wire inspection	OFF			There is less than 1 Ohms
	Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.
	VOUT_RR_R shorted to ground inspection	OFF			There is more than 1 MOhms
	TS_RR_R shorted to ground inspection	OFF			There is more than 1 MOhms
	DL_RR_R shorted to ground inspection	OFF			There is more than 1 MOhms

Results 

• If it is abnormal, there is a problem in the circuit.

Driver's Door Outer Handle Inspection 

NOTE:  Since there is no direct method to test the inspection item, troubleshooting is performed using a known-good component.

Test Procedure 

• Install a known-good driver's door outer handle and attempt to reproduce the failure.

Results 

• If the failure is reproduced, there is a problem with other related components.
• If the symptom/DTC goes away, the driver's door outer handle must be faulty.

Front Passenger's Door Outer Handle Inspection 

NOTE:  Since there is no direct method to test the inspection item, troubleshooting is performed using a known-good component.

Test Procedure 

• Install a known-good front passenger's door outer handle and attempt to reproduce the failure.

Results 

• If the failure is reproduced, there is a problem with other related components.
• If the symptom/DTC goes away, the front passenger's door outer handle must be faulty.

Left Rear Door Outer Handle Inspection 

NOTE:  Since there is no direct method to test the inspection item, troubleshooting is performed using a known-good component.

Test Procedure 

• Install a known-good left rear door outer handle and attempt to reproduce the failure.

Results 

• If the failure is reproduced, there is a problem with other related components.
• If the symptom/DTC goes away, the left rear door outer handle must be faulty.

Right Rear Door Outer Handle Inspection 

NOTE:  Since there is no direct method to test the inspection item, troubleshooting is performed using a known-good component.

Test Procedure 

• Install a known-good right rear door outer handle and attempt to reproduce the failure.

Results 

• If the failure is reproduced, there is a problem with other related components.
• If the symptom/DTC goes away, the right rear door outer handle must be faulty.

Driver's Door Control Unit Inspection 

NOTE:  Since there is no direct method to test the inspection item, troubleshooting is performed using a known-good component.

Test Procedure 

• Install a known-good driver's door control unit and attempt to reproduce the failure.

Results 

• If the failure is reproduced, there is a problem with other related components.
• If the symptom/DTC goes away, the driver's door control unit must be faulty.

Body Control Module Inspection 

Test Procedure 

• If the other inspection item(s) indicated a normal condition, then it is determined that the remaining body control module is the cause.

Results 

• There is a problem with the body control module.