Installation Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Install the bulb.
Install the bulb socket by turning the socket clockwise.
Install the lamp assembly.
Engage the clips retaining the lamp.

Fig 1: Daytime Running Lamp

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the nuts to the rear of the lamp assembly.
Tighten: Tighten the nuts to 6 N.m (53 lb in).
Connect the electrical connector.