LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 565 (Lighting Systems) >> Repair Instructions >> Headlamp Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wiring Harness & Headlamp
    GM1467135Courtesy of GENERAL MOTORS CORP.
  1. Open the hood.
  2. Connect the wiring harness.
  3. Install the headlamp.
  4. Ensure the alignment pin (4) is positioned to the housing (2).
    5. Fig 2: Retaining Nuts & Connecting Electrical Connector
    GM1467132Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the retaining nuts (3).

    Tighten:  Tighten the nuts to 6 N.m (53 lb in).

  6. Connect the electrical connector (4) to the headlamp bulb socket.
  7. Close the hood.
  8. Install the grille. Refer to Grille Replacement in Exterior Trim.
scientia non olet · About LEMON Manuals