LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (Entertainment System) >> Repair Instructions >> Antenna Cable Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Antenna Cable & Extension Cable
    GM1416172Courtesy of GENERAL MOTORS CORP.
  1. Attach a mechanics wire to the replacement antenna cable (1).
  2. Pull the mechanics wire to route the replacement antenna cable.
  3. Remove the mechanics wire from the antenna cable.
  4. Connect the antenna cable (1) to the extension cable (2).
  5. Install the right kick-up panel. Refer to Kick-Up Panel Replacement - Front Floor in Interior Trim.
  6. Install the right front sill plate. Refer to Door Sill Plate Replacement - Front in Interior Trim.
    7. Fig 2: Fastener & Mast Base
    GM1415783Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the 3 screws (1) retaining the mast base.

    Tighten:  Tighten the screws to 35 N.m (26 lb ft).

  8. Install the fastener (2) to the mast base.
    9. Fig 3: Front Fender Upper Hole Cover
    GM1415780Courtesy of GENERAL MOTORS CORP.
  9. Install the front fender upper hole cover (4).
  10. Install the 2 screws (3) retaining the front fender upper hole cover.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  11. Install the antenna mast (2).
  12. Install the antenna boot (1).
  13. Close the hood.
scientia non olet · About LEMON Manuals